The two technologies are not compatible. Is there any reason an FPDlink SER cannot be used? I can provided compatible device to the ADI MAX96724/F/R.

We would like to know the Switching frequency used by the Internal 1.2V Switching DCDC Converter on the TMS320F28004x DSC.

The value of Rfilter is 100 ohms, 0.1% tolerance, for each resistor <- while this value is 10x the recommended value, I suspect it does not have a great impact on our operation, your feedback would be ...

I want to use interconnect studio. I have read the User'sGuide.However,I was unable to access 「interconnect_studio.itg.ti.com.」 ...

Hi，I am using the bq40z50-r2 chip for 2S1P battery packs. I now want the battery pack to be able to actively turn on the discharge MOS when plugged into the power supply device, and then automatically ...

I am calculating the power consumption of all components on my circuit for thermal simulation. The circuit is the same as typical application circuit in the datasheet below and all FETs are ...

I am using the EMIF interface to access both an external SRAM and an FPGA. Do you recommend adding series resistors (10-22 ohms each) to the EMIF signal lines, since the interface will be running at ...

I am working with the TIDEP-01032 example from the AM243x Motor Control SDK 09.02.00 and don't understand how the EtherCAT Firmware is loaded onto the PRU-ICSSG. In the EtherCAT Slave Simple Demo, ...

28335 tx to RS232 converter tx to (connected DB9 connecter) to DB9 connecter tx to DB9 connecter rx to RS232 rx to TMS320F28069 rx 28335 rx to RS232 converter rx to ...

When the TX_PLL of AFE7769 is set at 880MHz, a large power DC will be generated, and the QMC automatic calibration cannot go down, affecting the ACPR, this problem has a small probability, about 1/250 ...

We heard 947 can detect FPD Lock and video Lock, we known FPD Lock is the bit 7 of register 0x5A, but what is the video lock of 947? And we heard the new version of 947 does not need the tempature ...